View and Download Polaris Magnum owner’s manual supplement online. Offroad Vehicle Polaris Sportsman HO International Owner’s Manual. Atv polaris sportsman / efi / x2 efi ( pages). Offroad Vehicle Polaris Magnum Owner’s Manual Supplement. Atv (5 pages). PN IMPORTANT: This is a supplement to your owner’s manual. This information should remain with your owner’s manual at.
|Published (Last):||8 October 2007|
|PDF File Size:||9.90 Mb|
|ePub File Size:||2.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
To prevent serious injury, do not operate vehicle with guard removed. Before shifting into reverse gear, always check for obstacles or people oqners the ATV.
Lift the pod slightly while depressing the tabs at the rear of the pod. See your dealer as outlined in the owner’s manual. Department of Transportation DOT label.
Driving Downhill When driving downhill, follow these precautions: Improperly performing the procedures marked with a component failure and cause an accident, which may result in serious injury or manua. Never install a hitch longer than 4″ 10 cm. Polaris also gives a one year limited warranty on the final drive chain for failure due to defects. Oil Pump Priming Oil and Filter Change Oil Pump Priming This priming procedure must be performed whenever the oil hose connection between the oil tank and pump inlet has been disconnected.
Remove the battery from the vehicle to prevent damage from leak- ing or spilled electrolyte during charging. Inspect clutch seals for damage if repeated leaking occurs. Headlight Lamp Replacement When servicing a halogen lamp, don’t touch the lamp with bare fingers.
Polaris Sportsman Manuals Refine Results. On conventional batteries, remove the battery vent tube. Always change the oil filter whenever changing oil.
Respect the environment in which you ride. To print the manual completely, please, download it. Be sure the storage area is well ventilated. Use of other fluids may result in improper operation of components.
Repeat the measurement procedure on the other side of the vehicle. The following signal words and symbols appear throughout this manual and on your vehicle.
Wheel Removal Front Wheel Hub Tightening Front wheel bearing tightness and spindle nut retention are critical com- ponent operations. Doing so can cause part failure, possible imbalance, and excessive engine RPM, which can result in serious injury or death. Always check for obstacles before operating in a new area.
1996 – 2004 Polaris 400 500 Sportsman ATV Online Service Manual
Troubleshooting Dry out the PVT. Don’t have an account? SportsmanSportsman h. See page for the part numbers of Polaris products.
Polaris recommends maintaining battery charge by using a Polaris Bat- tery Tender charger or by charging about once a month to make up for normal self-discharge.
Excessive speed when traveling downhill can cause loss of control. What a step backwards. Number of bids and bid amounts may be slightly out of date. Use the K-turn to turn around. Operation is prohibited for those under 16 years of age. Reinstall the harness assembly into the headlight assembly. Loss of control can result in severe injury or death.
POLARIS SPORTSMAN HO OWNER’S MANUAL Pdf Download.
Skip to main content. Towing Loads ATV warranty. Remove the battery cover.
If the fluid level is low and the diaphragm is not extended, a leak is polarus and the diaphragm should be replaced. Safety Warnings Handling Gasoline Gasoline is highly flammable and explosive under certain conditions. Air Filter Air Filter 1. When the engine is idling, move the lever to the desired gear. Warranty or Service Bulletin repairs must be done by an authorized Polaris dealer.
Page 68 if equipped Transmission oil Engine breather filter if equipped Perform these procedures more often for vehicles subjected to severe use. Remove the left side panel. Sortsman show me this message again.
Owner’s Manuals | Polaris
Cover the vehicle with a genuine Polaris cover. Fuse Replacement If the engine stops or will not start, or if you experience other polwris failures, a fuse may need replacement. For vehicle storage and when transporting. Cleaning And Storage Do not allow these types of products to contact the vehicle.
Wash the pre-filter in soapy water, then rinse and let dry. Inspect, clean, lubricate, adjust and replace parts as necessary. The electrodes are not burned or eroded.