Test Method for Determination of Hydraulic Conductivity of Porous Material Using a Rigid-wall Compaction-Mold Permeameter. Start. Standard ASTM standard · ASTM D Status: Withdrawn · Replaced by: ASTM D Soil and Rock (I): D – D (ASTM VOL ). ASTM D Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold.
|Published (Last):||1 December 2015|
|PDF File Size:||16.99 Mb|
|ePub File Size:||14.83 Mb|
|Price:||Free* [*Free Regsitration Required]|
Therefore, the results should be applied to field situations with caution and by qualified personnel. Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors. The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Activation of your subscription failed – please try again later or contact us. You must be logged in to sign up for monitoring You must be logged in to sign up for subscription.
Are you sure you want to d58856 It was not possible to unsubscribe – please try again later or contact the Danish Standard Please make sure you are logged in.
There is a problem adding monitoring – please try again later There is a problem adding the subscription – please try again later. Test Method D is recommended for any material that tends to shrink when exposed to the permeant liquid.
Kontakt venligst Dansk Standard. Referenced Documents purchase separately The documents d55856 below are referenced within the subject standard but are not provided as part of the standard.
However, this test method does not ensure complete saturation of the test specimen with water. However, when the hydraulic gradient acting on a test specimen is changed, the state of stress will also change, and, if the specimen or pore fluid is compressible, the volume of the test specimen or pore fluid will change. The printed version is available at half price when you buy the electronic version. Please choose number of devices you want to open the document on. Historical Version s – view previous versions of standard.
Permeation with other liquids, such as chemical wastes, can be accomplished using procedures similar to those described in this test method.
The aetm conductivity of compacted materials that have hydraulic conductivities greater than 1? It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Activation of monitoring failed – please try again later or contact us. In cases where it is essential to saturate the test specimen fully with water, the compacted specimen may be tested using Test Method D It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applic. Link to Active This link will always route to the current Active version of the standard.
Are you sure you want to unsubscribe monitoring?
It is not possible to buy in the shop – please contact us. This test method applies to porous materials containing little or no air. Continue shopping Proceed to checkout. The test method is designed to minimize the amount of air in the test specimen.
ASTM D5856 – 15
However, astn test method is only intended to be used when water is the permeant liquid. Du abonnerer allerede dette emne. Username or password invalid. Atm not show this again. The problem tends to be of minimal significance for materials that swell when exposed to water for example, compacted, clayey soils but can be a very serious problem for materials that might tend to shrink and pull away from the walls of the permeameter.
ASTM D Standard
Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. Experience has sometimes shown that flow atsm in small, laboratory-prepared test specimens do not necessarily follow the same patterns on large field scales and that hydraulic conductivities measured on small test specimens are not necessarily the same as larger-scale values. By tradition in U.
By tradition in U.