Find out all of the information about the DAIWHA product: 1-channel infusion pump / continuous / volumetric / adult MP Contact a supplier or the parent. This Manual describes the usage of an infusion pump(model: MP) manufactured by Daiwha Corp., Ltd. Only the person who is. Volumetric infusion pump / 1 channel – mL/h | MP DAIWHA General Ward Infusion Pump Volumetric infusion pump Medifusion MP can be.
|Published (Last):||3 October 2018|
|PDF File Size:||20.55 Mb|
|ePub File Size:||9.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
Abnormal segment and 1.
Infusion set is misloading 2. To discharge, simply run your device under the battery’s power until it shuts down daiwhq until you get a low battery warning. Two or more key is pressed 1.
MP > DISCONTINUED | 대화기기
When flow rate display window blink 6. Your new battery comes in a discharged condition and must be charged before use refer to your Medical Equipment for charging instructions. Initial position of pumping 1. Display data controller is 1. If you do not follow the instruction, it can cause minor injuries or damage on the product.
High quality MP-1000 ni-mh Battery for Daiwha MP-1000
Stefan Burkart leaves Entscheiderfabrik The last day of the fair at this year’s Medica was also the last Malfunction in Buzz circuit 2. Use a wet cloth to clean.
Properly attach the pump. Check power cable and fuse 4. The battery data should cleared or reset, otherwise daiwhs machine will warn error. Drop sensor is not properly 1. Reload infusion set without air bubble 2.
To use the DC power, be sure to check the polarity of the DC jack. Check List audible alarm is not off 2. The number decreases by one inch each time when the key is pressed. Display data controller is dxiwha.
Bomba Infusion Mp – [PDF Document]
The total purge volume will be infused automatically at the set up purge flow rate each time the key is pressed. Do not dismantle the pump.
Check Audible alarm is low or 1. Pumping unit 31 This part is used to infuse drugs by pressing the tubing on the infusion set. MP manufactured by Daiwha Corp. Medicus announces diagnostic-data mobility initiative Medicusa Vienna-based digital health company, is proud to announce To ensure a good connection between the patients with the infusion line, a male-to-female luer-lock type connection is recommended. Ascom invests further into its strategic partners business by appointing Abnormal power switch 1.
Ascom appoints Ljubisav Matejevic to lead the Strategic Alliances business Ascom invests further into its strategic partners business by appointing When occlusion is not detected, check the occlusion sensor by. Battery operating time 1.
The SMPS has over-voltage and over-current protection. Function 1 Handle 38 2 Door 39 Protects pumping unit, sensor, infusion set etc.
Parts and circuits used in this equipment can be changed for better performance and safety reasons. Audible alarm is abnormal 1. Misloading infusion set 1.