FIGURES, CHARTS, AND TABLES IN THE ISD SERIES DATA SHEET . ISD Series Device Pin/Pad Designations, with Respect to Die Center (µm). ISDMP Datasheet, ISD SPI Interface Record and Playback IC Datasheet, buy ISDMP Voice Record IC. ISDMP datasheet, ISDMP circuit, ISDMP data sheet: WINBOND – Single-Chip Voice Record/Playback Devices 8-, , , and.
|Published (Last):||17 October 2010|
|PDF File Size:||5.81 Mb|
|ePub File Size:||19.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
All other trademarks are the property of their respective owners. Copy your embed code and put on your site: Oct 31, Revision If the XCLK is not used, this input must be connected to ground. This is the serial input to the ISD device when it is configured dataaheet slave.
Oct 31, – 2 – Revision 1.
In this mode, the messages are skipped 1, times faster than the normal playback mode. Download datasheet Kb Share this page. Message Cueing can be selected only at the beginning of a playback operation.
Refer to the AC timing table for other T to different sampling rates. When a record command is sent, T  Measured with AutoMute feature disabled. Oct 31, – 4 – Revision 1.
Remove the leaded package option Remove the extended temperature option Update the external clock description Revise Ordering Information section 1.
This is the serial output of the ISD device Otherwise the ISD will repeat the operation from the same row address.
ISD Datasheet PDF –
Care should be taken such that the data shifted in is compatible with current system operation possible to dataseet interrupt data and start a new operation at the same time Memory Architecture The ISD ise4004 contains a total of 3,K Flash memory cells, which is organized as 2, rows of 1, cells each.
The address bits A0-A15 are used to access various rows for multiple messages of different durations. Oct 31, – 1 – Revision 1. Oct 31, Revision 1. Elcodis is a trademark of Elcodis Company Ltd. Exposure to the absolute maximum ratings may affect device reliability and performance.
The duty cycle on the input clock is not critical, as the clock is immediately divided by two. To minimize noises, the analog and digital circuits in the ISD devices use separate power busses.
Playback and record operations are initiated when the device is enabled by asserting the SS pin LOW, shifting in an opcode and an address data to the ISD device refer to the Opcode Summary in the following page. Functional operation is not implied at these conditions.
ISDMPY – Nuvoton – PCB Footprint & Symbol Download
The ISD series is designed to be used in a microprocessor- or microcontroller-based system. In addition, the device can be re- recorded typically overtimes.
The CMOS-based devices include an on-chip oscillator, is4d004 filter, smoothing filter, AutoMute feature, audio amplifier, and high density multilevel Flash memory array. In addition, these supplies should be decoupled as close to the package as possible.
Stresses above those listed may cause permanent damage to the device.